Owner's Manual

15
OPERATION
ADJUSTING THE DETHATCHER DEPTH (See Figure 6)
C A U T I O N
BEFORE YOU ADJUST THE DETHATCHER DEPTH, TURN OFF THE POWER, UNPLUG THE
TOOL AND ENSURE THE MOTOR HAS STOPPED.
• The dethatcher depth is adjusted by turning the hubcaps. You can choose from three different
depth settings by pulling out and turning hubcaps.
• When setting “I” is at the bottom, the high setting is locked in. The dethatcher depth is approx 1
mm above the ground. Select depth setting “I” when transporting the dethatcher.
• When setting “II” is at the bottom, the middle setting is locked in. The dethatcher depth is
approx 1/8” (3 mm).
• When setting “III” is at the bottom, the low setting is locked in. The dethatcher depth is approx
3/8” (10 mm).
C A U T I O N
THE HUBCAPS MUST BE FIRMLY LOCKED INTO PLACE! AT THE BEGINNING IT IS BEST
TO SELECT DEPTH SETTING ”I” AT THE START. YOU CAN THEN SWITCH TO SETTING “II”
WHEN THE DETHATCHER SPIKES HAVE BECOME WORN.
Fig. 6