User manual

ManualsBrandsGREISINGER ManualsTemperature GaugesThermometer GTH 200 AIR -20 up to +70 °C Sensor type Pt1000

H62.0.31.6C-02

GREISINGER electronic GmbH

D - 93128 Regenstauf, Hans-Sachs-Straße 26

 +49 (0) 9402 / 9383-0  +49 (0) 9402 / 9383-33  info@greisinger.de

as of version 2.1 GTH 200 air

WEEE-Reg.-Nr. DE 93889386

Operating manual

Fast precision air thermometer



Please carefully read these instructions before use!



Please consider the safety instructions!



Please keep for future reference!

Summary of content (8 pages)

PAGE 1
H62.0.31.6C-02 Operating manual Fast precision air thermometer GTH 200 air as of version 2.1    Please carefully read these instructions before use! Please consider the safety instructions! Please keep for future reference! WEEE-Reg.-Nr. DE 93889386 GREISINGER electronic GmbH D - 93128 Regenstauf, Hans-Sachs-Straße 26  +49 (0) 9402 / 9383-0  +49 (0) 9402 / 9383-33  info@greisinger.
PAGE 2
H62.0.31.6C-02 Operating manual GTH 200 air _____________________________________________________ page 2 of 8 _____________________________________________________________________________ Index 1 2 3 4 5 6 7 8 GENERAL NOTE ...................................................................................................................................................... 2 SAFETY ...........................................................................................................................
PAGE 3
H62.0.31.6C-02 Operating manual GTH 200 air _____________________________________________________ page 3 of 8 _____________________________________________________________________________ 2.2 Safety signs and symbols Warnings are labeled in this document with the followings signs: Caution! This symbol warns of imminent danger, death, serious injuries and significant damage to property at non-observance.
PAGE 4
H62.0.31.6C-02 Operating manual GTH 200 air _____________________________________________________ page 4 of 8 _____________________________________________________________________________ 2.1 Operation and maintenance advice a.) Battery operation: If BAT is shown in the left part of the display the battery has been used up and needs to be replaced. However, the device will operate correctly for a certain time. The battery has to be taken out, when storing device above 50°C.
PAGE 5
H62.0.31.6C-02 Operating manual GTH 200 air _____________________________________________________ page 5 of 8 _____________________________________________________________________________ 3.5 Display of min-/max- value memory For all measuring values the lowest and highest measured value since the switch-on of the device will be stored.
PAGE 6
H62.0.31.6C-02 Operating manual GTH 200 air _____________________________________________________ page 6 of 8 _____________________________________________________________________________ 5 Offset- (Zero point) and Slope Adjustment The temperature measuring value can be readjusted by the following settings. However, please consider that the integrated sensors are very precise and readjustment is very rarely needed. Erroneous settings of the parameters will probably cause by far higher errors than e.g.
PAGE 7
H62.0.31.6C-02 Operating manual GTH 200 air _____________________________________________________ page 7 of 8 _____________________________________________________________________________ 7.2 Disposal instructions Batteries must not be disposed in the regular domestic waste but at the designated collecting points. The device must not be disposed in the unsorted municipal waste! Send the device directly to us (sufficiently stamped), if it should be disposed.
PAGE 8
H62.0.31.