Use and Care Manual

-14-
G0457 14" Industrial Bandsaw (Mfd. Since 5/11)
Inventory
Contents (Figures 4–5) Qty
A. Bandsaw Unit ............................................. 1
B. Cabinet Stand ............................................. 1
C. F e e t
3
⁄8-16 (Stand) ...................................... 4
D. Motor .......................................................... 1
E. Guide Post Adjustment Knob ..................... 1
F. Blade Tension Quick Release Lever .......... 1
G. Table ........................................................... 1
H. Trunnion Hand Knobs M10-1.5 (Table) ....... 2
I. Miter Gauge ................................................ 1
J. Fence Assembly ......................................... 1
K. Resaw Fence ............................................. 1
L. Front Rail .................................................... 1
M. Rear Rail .................................................... 1
N. Moving Plate (Fence).................................. 1
O. Resaw Lock Handle w/Nut (Fence) ............ 1
P. Fence Lock Lever (Fence) .......................... 1
Hardware (Not shown)
• Cap Screws M8-1.25 x 20 (Motor) .............. 2
• Lock Washers 8mm (Motor) ....................... 2
• Fender Washers 8mm (Motor) ................... 2
• Flat Washers 6mm (Front Rail) .................. 2
• Lock Washers 6mm (Front Rail) ................. 2
• Hex Bolts M6-1 x 20 (Front Rail) ................ 2
• Cap Screws M6-1 x 16 (Rear Rail) ............. 2
• Hex Bolt M8-1.25 x 80 (Positive Stop) ........ 1
• Hex Nut M8-1.25 (Positive Stop) ................ 1
• Carriage Bolts M8-1.25 x 20 (Stand) .......... 6
• Flange Nuts M8-1.25 (Stand) ..................... 6
• Hex Nut M8-1.25 (Quick Release Lever) .... 1
• Hex Nut M8-1.25 (Fence Lock Lever) ......... 1
• Flat Washer 8mm (Resaw Lock Handle) .... 1
• Hex Nuts
3
⁄8-16 (Feet) ................................. 4
• Flat Washers 10mm (Feet) ......................... 4
• Hex Wrench 6mm ....................................... 1
• Flange Screw M6-1 x 8 (Guide Post Knob ) 1
Figure 4. Bandsaw, stand, motor, and
components
A
C
B
Figure 5. Table, miter gauge, and hardware
bags.
D
E
Figure 6. Main fence components.
F
G
H
I
J
K
L
M
N
O
P
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.