Use and Care Manual

-12-
Model T28798 (Mfd. Since 01/20)
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Loose Components (Figure 2) Qty
A. Casters ....................................................... 4
B. Dust Port .................................................... 1
C. Y-Inlet ......................................................... 1
D. Collection Drawer ....................................... 1
E.
Pleated Micro Filter .................................... 1
F.
Active Carbon Filter .................................... 1
G.
Stainless-Steel Mesh Filter......................... 1
H.
Dust Tray .................................................... 1
Hardware (Figure 3) Qty
I. Flange Bolts
5
⁄16"-18 x
1
⁄2" ......................... 16
J. Button Head Cap Screws
5
⁄16"-18 x
1
⁄2" ....... 4
K.
Hex Wrench 5mm ....................................... 1
L.
Open-End Wrench 10 x 12mm ................... 1
M.
Flange Screw #10-24" x
3
⁄8" ........................ 1
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Figure 3. Hardware inventory.
10 12
J
I M
K
L
Figure 2. Loose components inventory.
B C
D
E
A
F
G
H