Use and Care Manual

Model T28798 (Mfd. Since 01/20)
-15-
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup
and gather
all
listed items.
To ensure the assembly process
goes smoothly, first clean any
parts that are
cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Figure 6. Attaching dust port.
Dust
Port
2. Attach dust port to side of dust collector with
(4)
5
⁄16"-18 x
1
⁄2" button head cap screws (see
Figure 6).
x 4
To assemble dust collector:
1.
Attach casters to bottom of dust collector
using (16)
5
⁄16"-18 x
1
⁄2" flange bolts, as shown
in Figure 5.
Figure 5. Attaching casters to bottom of dust
collector.
x 16
Note: Do not destroy packaging until after the Test
Run.
3. Attach Y-inlet to dust port with (1) #10-24 x
3
⁄8" flange screw (see Figure 7).
Y-Inlet
Figure 7. Attaching Y-inlet to dust port.
x 1