Operation Manual

123
GB
Fitting the collection bag
4. Place the retainer frame (15) onto the
opening on the motor casing (11) such
that the click-in fasteners (21) audibly
click into place.
5. Fix the loops (18a+b) from the collection
bag (16) to the upper blower/suction
tube (2b) and the device casing (11).
Mount carrying strap:
6. Hook the carrying strap (1) onto the at-
tachment bar (8).
Operation
Danger of injury.
Wear suitable clothing and work
gloves when working with the
device. Make sure that the device
is functioning properly before
every use. Make sure that the
collection bag and the tube are
assembled correctly and the car-
rying strap is adjusted correctly
for work. If a switch should be
damaged, work with the device
must not be carried out any
longer. Make sure that the mains
voltage values are compatible
with the label on the device.
Note noise protection laws and lo-
cal regulations.
Operate the device only at reason-
able times – not early in the morn-
ing or late in the evening when
others could be disturbed.
After switching off the device,
the impeller wheel continues to
rotate for some time. Danger of
injury due to rotating tool.
Initial Operation (picture 3)
Before switching on device, make
sure it is not in contact with any
objects. Ensure stable positioning.
The device can only be switched
on if the entire blower / suction
tube is correctly mounted.
picture 3
5
9
4
7
8
13
14
1. Make a loop of the end of the exten-
sion cord and fasten this to the cable
support (13). By means of this tension
relief, an unintentional pull-out of the
electrical plug connection is avoided.
2. Make sure that the device is switched
off and connect the device to the
mains voltage.
3. Put on the carrying strap (5) and adjust
it to the optimum length.
During operation, hold the device with
one hand on the casing grip and the
other on the additional grip.
4. In order to select the operation mode,
turn the operation mode selector (14)
to the symbol required.
Suction operating mode
Blowing operating mode