Operation Manual

9
Sonoclock 22/22Q/32 page 9
GB
Wake-up by radio
• Set the function selection switch 0 y ɷ to
position 0 (on).
• Select a station which will be broadcasting at
the alarm time and adjust the volume to the
required level.
• Set the function selection
switch to position ɷ.
– At the preselected alarm
time the radio will switch
on and switch off again
automatically 1 hour and
59 minutes later.
Wake-up by sound signal
• Set the function selection
switch to position .
– At the preselected alarm
time the sound signal will
switch on and switch off
again automatically 1
hour and 59 minutes
later.
Interrupting and repeating the
alarm
• The radio alarm or electronic sound alarm can
be interrupted with the SNOOZE button.
– After 9 minutes, the alarm comes on again.
• It is possible to interrupt the alarm function
several times during the switch-on period.
– The alarm remains set to operate the next day.
Positioning the set
Caution should be exercised if the set is placed
on furniture as surfaces are often coated with
lacquers and plastic finishes containing additives
which attack the material of which the feet of the
set are made, leaving stains which can only be
removed with difficulty or not at all.
Further notes:
• Only a soft cloth which picks up dust should
be used to clean the cabinet. Do not use
aggresive polishes or cleaning agents.
• Do not expose the unit to moisture (e.g.
dripping or splashing).
• The type label is on the bottom of the unit.
Technical specifications
Wavebands: FM ................87.5 – 108 MHz
MW..........526.5 – 1606.5 kHz
(Sonoclock 22/22 Q)
LW..............148.5 – 283.5 kHz
(Sonoclock 32)
Power output:................760 mW peak power
The unit meets the CEE regulations concerning
interference radiation.
This product fulfills European directives
89/336/EEC, 73/23/EEC and 93/68/EEC.
This set complies with the safety regulations
according to VDE 0860 / BS 415 and thus
with the international safety regulations
according to IEC 65.
Subject to technical alterations and alterations
in styling. E & O.E.
Switching off the alarm
• The alarm function can be switched off by
pressing ALARM once. You can also press the
SLEEP and then the SNOOZE button.
– The alarm remains set to operate the next day.
• If you wish to switch off the alarm completely,
set the function selection switch to position y.
– The light dot ALARM goes out.
Going to sleep while listening to
the radio
• Press the SLEEP button briefly.
– The unit switches on the radio and the display
will show a switch-on period of 59 minutes.
• The 'sleep' time can be adjusted between 0
minutes and 1 hour and 59 minutes by
keeping the SLEEP button pressed and then
pressing the HOUR /
MIN buttons.
• If you press the SLEEP button, the 'sleep' time
will go back to 59 minutes.
– After the preset sleep time has elapsed, the
radio will switch off automatically.
• The SLEEP function can be terminated prema-
turely by pressing the SNOOZE button.
ALARM GENERAL