User's Manual

11
Land your model immediately when the battery begins to
lose power. Recharge the battery before attempting another
fl ight. A dangerous situation can occur when attempting to
recharge an over-discharged battery!
● ALWAYS charge the battery inside a fi reproof container placed in a
fi reproof location clear of combustible materials. Failure to do so can
result in property damage and/or bodily harm!
● ALWAYS keep charging batteries within eyesight. Leaving the
battery unattended is dangerous!
● ALWAYS keep a supply of sand accessible when charging. Dumping
sand on the battery will extinguish the LiPo chemical fi re.
● NEVER use anything EXCEPT a LiPo approved charger.
● NEVER charge over 4.20V per cell.
● NEVER charge at currents greater than 1C.
● NEVER charge through the “To ESC” or “DISCHARGE” lead.
● NEVER trickle charge, or allow the battery to discharge below 2.75V
per cell.
● NEVER allow the battery temperature to exceed 140° F [60° C].
● NEVER disassemble or modify the pack wiring in any way or
puncture cells.
● ALWAYS KEEP OUT OF REACH OF CHILDREN.
Electric Motor Warning
Electric motors are very dangerous. Do not work on the model while the fl ight
battery is plugged in as interference may cause the main rotor blades to spin,
possibly causing injury to yourself.
WARNING!! Once the fl ight battery is connected the helicopter will have full
power available. You must take proper measures to ensure that the throttle
stick is not moved and that the idle up switch is not turned on while handling
the model.