User's Manual

NOVUS CP – REPLACING THE FLYBAR

Loosen the screws on

both ﬂ ybar paddle collars.

Rotate the paddles counter

clockwise to remove the

paddle and the collar from

the ﬂ ybar. Loosen the

screws on the ﬂ ybar carrier

(both sides). At this point

the ﬂ ybar can be slid out of

the ﬂ ybar carrier. Slide the

new ﬂ ybar into the ﬂ ybar

carrier and ensure that

the new ﬂ ybar is centered. Tighten the ﬂ ybar carrier screws and reinstall the

paddles. Ensure that the paddles are equal distances out on the ﬂ ybar and

tighten the ﬂ ybar paddle collar screws.

NOVUS CP – REPLACING THE MAIN GEAR

Remove the lower retaining

pin from the main gear

using needle nose pliers.

Remove the old main gear

from the model and install

the new main gear. Align

the hole in the main shaft

with the hole in the main

gear and press the small

pin back through the hole.

NOVUS CP – REPLACING THE MAINSHAFT

Remove the lower

retaining pin from the main

gear using needle nose

pliers. Disconnect the

servo linkages from the

swashplate. Slide the main

shaft straight up and out of

the main frame. Remove

and transfer necessary

parts to the new main shaft

and reinstall by reversing

the order listed above.