User's Manual

Instructions
1. Connect the Ethernet cable to the RJ45 Jack at the bottom of the YLAP.
2. Connect an USB cable to external 5V output power adapter.
3. Plug in the USB Type-C power supply cable to the power jack next to the RJ45 Jack.
4. Wait for YLAP to acquire ip address from router, for about 30 seconds from power on.
5. Check that YLAP status has changed to be online on server.
6. Then, any refresh queue will be committed to YLAP from server, YLAP will direct the refresh
procedures and response to the server corresponding result.
Operating Frequency
2405MHz~2470MHz
Modulation
O-QPSK
Number of Channels
14 Channels
Antenna Type
PCB Antenna
Antenna Gain 0dBi
RF Function