Use and Care Guide

ManualsBrandsGunVault ManualsGun SafesMicroVault MV550-19 Portable Safe with Illuminated Eyes Keypad and Security Cable- Black

STEP 1 - Open the unit by using either your backup keys

or current access code and locate the Learn button,

which can be found on the interior panel of the unit.

STEP 2 - Use steps 3-7 in the Programming section to

change your current combination.

STEP 3 - Now you have successfully reprogrammed

your safe. Test your access code to conﬁrm that your

unit has been properly programmed.

STEP 4 - Your safe is now ready for use.

Safety Features

Entering an invalid access code triggers the Tamper

Detect Feature.

STEP 1 - Press and hold down buttons 2 and 3 for ﬁve

seconds to initiate the tamper detect indicator.

STEP 2 - If tampering has been detected, the indicator

light will remain red until buttons 2 and 3 are released.

STEP 3 - If tampering was not detected, the indicator

light will remain green until buttons 2 and 3 are

released.

Tamper Detection

This feature turns audio for unit on and oﬀ.

STEP 1 - Open the unit and locate the Mute button on

the interior panel of the unit.

STEP 2 - Press and hold the Mute button for three

seconds. The keypad back lighting will remain red while

the mute button is held down. Once the keypad back

lighting ﬂashes green and the unit beeps three times,

you should release the button.

STEP 3 - Now you have successfully activated/deactivat-

ed the mute feature.

Audio Control

High-strength steel security cable. It should only be

used to securely tether the product around a sturdy

object.

STEP 1 -

Loop the cable around a sturdy object.

STEP 2 - Find the end of the cable with the metal tip

and run it through the eye of the other end and pull

tight around the sturdy object.

STEP 3 - Place the metal end of the security cable

through the ﬁtted slot on the top left side of the unit

and close the lid to secure the cable.

Security Cable

STEP 1 - Open the unit by using either your backup keys

or current access code.

STEP 2 - Once opened, locate the metal slot on both

sides of the interior roof of the unit.

STEP 3 - Take the metal portion of the elastic strap and

insert into metal slot on either side.

STEP 4 - Repeat previous step to install on other side.

STEP 5 - Now you have installed your elastic strap.

Installing Elastic Strap

STEP 1 - When you enter the correct combination and

the battery is low, the keypad back lighting will ﬂash red

and beep six times. Depending on how low the battery

is, the unit may sound when releasing the lock. If the

battery is completely depleted you will only hear a light

humming sound.

STEP 2 - Replace your battery by using steps in section

labeled “Battery Installation”.

*The low battery indicator only operates when you

are in the process of opening your unit.

Low Battery Warning

Indicator

• After six incorrect entries, the Security Sleep Mode

feature will be triggered and will lockout any new

keypad entries for two minutes. When Security Sleep

Mode is active and a button is pressed, the keypad back

lighting ﬂashes red and the unit will beep three times.

• To verify that the Security Sleep Mode is deactiva-

ted, wait two minutes and then test your unit by slowly

typing in your combination. If the keypad back lighting

ﬂashes green, your combination has been accepted

and the unit will open. If the keypad back lighting

ﬂashes red, your combination is incorrect and you will

need to try again. If you have forgotten or lost your

combination, please follow the instructions on

Programming. Your backup key will be required if

reprogramming is needed.

Security Sleep Mode

Resetting Passcode

MicroVault XL Unit Only