Manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
GDS-2000A Programming Manual
12
Configure GPIB
Note
To use GPIB, the optional module, DS2-GPIB, must be
installed. Please see the user manual for installation
details.
Connection
1. Connect a GPIB cable from a PC to the installed
GPIB module.
Configure GPIB
2. Press the Utility key.
Utility
3. Press I/O from the bottom menu.
4. Use the Variable knob to set the
GPIB Address from the side menu.
This option will only be available
when the GPIB module is installed.
Range
1 ~ 30
GPIB Constraints
Maximum 15 devices altogether, 20m cable
length, 2m between each device
Unique address assigned to each device
At least 2/3 of the devices turned On
No loop or parallel connection