Manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
GDS-2000A Programming Manual
120
:TRIGger:LLEVel
Set
Query
Description
Sets or queries the low trigger level.
Note
Applicable for Rise and Fall/Pulse Runt triggers.
Syntax
:TRIGger:LLEVel {TTL | ECL| <NRf> | ?}
Related
commands
:TRIGger:TYPe
Parameter
<NRf>
Low level value.
TTL
Sets the low trigger level to TTL.
ECL
Sets the log trigger level to ECL.
Return parameter
<NR3>
Returns the trigger low level.
Example1
:TRIGger:LLEVel TTL
Sets the trigger low level to TTL.
Example2
:TRIGger:LLEVel -3.30E-3
Sets the trigger low level to -330mV/mA.
:TRIGger:EDGe:SLOP
Set
Query
Description
Sets or queries the trigger slope.
Syntax
:TRIGger:EDGe:SLOP {RISe | FALL | EITher | ? }
Related
commands
:TRIGger:TYPe
Parameter
RISe
Rising slope
FALL
Falling slope
EITher
Either rising or falling slope
Return parameter
Returns the trigger slope.
Example
:TRIGger:EDGe:SLOP FALL
Sets the trigger slope to falling.