Manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
GDS-2000A Programming Manual
130
:TRIGger:EXTERnal:PRObe:TYPe
Set
Query
Description
Sets or queries the external probe type.
Syntax
:TRIGger:EXTERnal:PRObe:TYPe { VOLTage | CURRent
| ? }
Related
commands
:TRIGger:EXTERnal:PRObe:RATio
Parameter
VOLTage
Voltage
CURRent
Current
Return parameter
Returns the probe type.
Example
:TRIGger:EXTERnal:PRObe:TYPe?
CURRENT
:TRIGger:EXTERnal:PRObe:RATio
Set
Query
Description
Sets or queries the external probe ratio
(attenuation).
Syntax
:TRIGger:EXTERnal:PRObe:RATio {<NRf> | ?}
Related
commands
:TRIGger:EXTERnal:PRObe:TYPe
Parameter
<NRf>
External probe attenuation factor.
Return parameter
<NR3>
Returns the probe attenuation factor.
Example
:TRIGger:EXTERnal:PRObe:RATio?
5.000000e+01
:TRIGger:BUS:TYPe
Query
Description
Returns the current bus type.
Syntax
:TRIGger:BUS:TYPe?
Return parameter
12C
I2C mode