Manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
141
:TRIGger:BUS:B1:PARallel:VALue
Set
Query
Description
Sets or queries the triggering data value for the
Parallel bus.
Syntax
:TRIGger:BUS:B1:PARallel:VALue {string | ? }
Related
commands
:BUS1:PARallel:WIDth
Parameter
<sting>
The number of characters in the string
depends on the data size setting. The
string must be enclosed in double
quotes, "string".
x = don’t care
1 = binary 1
0 = binary 0
Return Parameter
Returns the data value.
Example1
:BUS1:PARallel:WIDth 8
:TRIGger:BUS:B1:PARallel:VALue "1x1x0101"
Sets the value to 1x1x0101
Example 2
:TRIGger:BUS:B1:PARallel:VALue?
1X1X0101
:TRIGger:LOGic:INPut:CLOCK:SOURce
Set
Query
Description
Sets or queries which channel is used as the clock
source.
Note
When “NONe” is selected as the clock source the
trigger will use the Pattern trigger type. (This is the
equivalent of the Data trigger on the scope panel)
Syntax
:TRIGger:LOGic:INPut:CLOCK:SOURce {NONe | D0 |
D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D 9 | D10 | D11 |
D12 | D13 | D14 | D15 | ? }