Manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
GDS-2000A Programming Manual
182
Related
commands
:SEARCH:TRIGger:BUS:B1:I2C:CONDition
Parameter
ADDR7
7 bit addressing
ADDR10
10 bit addressing
Return Parameter
0
7 bit addressing
1
10 bit addressing
Example
:SEARCH:TRIGger:BUS:B1:I2C:ADDRess:MODe?
0
The addressing mode is current set to 7 bits.
:SEARCH:TRIGger:BUS:B1:I2C:ADDRess:TY
Pe
Set
Query
Description
Sets the I
2
C bus address type, or queries what the
setting is for the search trigger.
Syntax
:SEARCH:TRIGger:BUS:B1:I2C:ADDRess:TYPe
{GENeralcall | STARtbyte | HSmode | EEPROM | CBUS
| ?}
Related
commands
:SEARCH:TRIGger:BUS:B1:I2C:CONDition
Parameter
GENeralcall
Set a general call address (0000 000 0).
STARtbyte
Set a start byte address. (0000 000 1)
HSmode
Set a high-speed mode address.
(0000 1xx x)
EEPROM
Set an EEPROM address.
(1010 xxx x)
CBUS
Set a CBUS address. (0000 001 x)
Return Parameter
Returns the address type
Example
:SEARCH:TRIGger:BUS:B1:I2C:ADDRess:TYPe?
CBUS