Manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
GDS-2000A Programming Manual
192
Related
commands
:BUS1:PARallel:WIDth
Parameter
<sting>
The number of characters in the string
depends on the data size setting. The
string must be enclosed in double
quotes "string".
x = don’t care
1 = binary 1
0 = binary 0
Return Parameter
Returns the data value.
Example1
:BUS1:PARallel:WIDth 8
:SEARCH:TRIGger:BUS:B1:PARallel:VALue "1x1x0101"
Sets the value to 1x1x0101
Example 2
:SEARCH:TRIGger:BUS:B1:PARallel:VALue?
1X1X0101
Digital Commands
:D<X>:DISPlay ........................................................... 193
:D<X>:POSition ......................................................... 193
:DISPlay:DIGital:HEIght ............................................ 193
:DIGital:GROUP<X>:THREshold .............................. 194
:DIGital:ANAlog:A<X>:DISPlay ................................. 195
:DIGital:ANAlog:A<X>:RATio .................................... 195
:D<x>:MEMory........................................................... 195
:D<x>:LMEMory ......................................................... 196
:DIGital:MEMory ....................................................... 197
:DIGital:LMEMory ..................................................... 198