Manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
APPENDX
209
-140, "Character data error"
-141, "Invalid character data"
-144, "Character data too long"
-148, "Character data not allowed"
-150, "String data error"
-151, "Invalid string data"
-158, "String data not allowed"
-160, "Block data error"
-161, "Invalid block data"
-168, "Block data not allowed"
-170, "Expression error"
-171, "Invalid expression"
-178, "Expression data not allowed"
-180, "Macro error"
-181, "Invalid outside macro definition"
-183, "Invalid inside macro definition"
-184, "Macro parameter error"
-200, "Execution error"
-201, "Invalid while in local"
-202, "Settings lost due to rtl"
-203, "Command protected"
-210, "Trigger error"
-211, "Trigger ignored"
-212, "Arm ignored"
-213, "Init ignored"
-214, "Trigger deadlock"
-215, "Arm deadlock"
-220, "Parameter error"
-221, "Settings conflict"
-222, "Data out of range"
-223, "Too much data"
-224, "Illegal parameter value"
-225, "Out of memory"
-226, "Lists not same length"
-230, "Data corrupt or stale"
-231, "Data questionable"
-232, "Invalid format"
-233, "Invalid version"
-240, "Hardware error"