Datasheet

X-Y MODE
X-Axis Input
Y-Axis Input
Phase Shift
Channel 1 ; Channel 3* ( * : four channel models only )
Channel 2 ; Channel 4* ( * : four channel models only )
±3° at 100kHz
DISPLAY SYSTEM
INTERFACE
SPECTRUM
ANALYZER
SPECIFICATIONS
AWG
SPECIFICATIONS
USB Port
Span
Frequency Range
Resolution Bandwidth
Reference Level
Vertical Units
Vertical Position
Vertical Scale
Display Average Noise Level
Spurious Response
Frequency Domain
Trace Types
Detection Methods
FFT Windows
Channels
Sample Rate
Vertical Resolution
Max. Frequency
Waveforms
Output Range
Output Resolution
Output Accuracy
Offset Range
Offset Resolution
Sine
Square/Pulse
Ramp
Ethernet Port (LAN)
Go/NoGo BNC
Kensington Style Lock
TFT LCD Type
Display Resolution
Interpolation
Waveform Display
Waveform Update Rate
Display Graticule
Display mode
Cursors
Automatic
Measurement
CONTROL PANEL
FUNCTION
Auto Counter
Autoset
Save Setup
Save Waveform
CURSORS AND
MEASUREMENT
8" TFT LCD WVGA color display
800 horizontal x 480 vertical pixels (WVGA)
Sin(x)/x
Dots, Vectors, Variable persistence(16ms~4s), Infinite persistence
120,000 waveforms per second, maximum
8 x 10 divisions
USB 2.0 High-speed host port x 1, USB 2.0 High-speed device port x 1
1kHz ~ 500MHz(Max.)
DC~500MHz(Max.) (Max. bandwidth ~500MHz uncalibrated)
1Hz ~ 500kHz(Max.)
-50 dBm to +40dBm in steps of 5dBm
dBV RMS; Linear RMS; dBm
-12divs to +12divs
1dB/div to 20dB/div in a 1-2-5 Sequence
1V/div < -50dBm, Avg : 16 ; 100mV/div < -70dBm, Avg : 16 ; 10mV/div < -90dBm, Avg : 16
2nd harmonic distortion< 40dBc ; 3rd harmonic distortion< 45dBc
Normal ; Max Hold ; Min Hold ; Average (2 ~ 256)
Sample ; +Peak ; -Peak ; Average
FFT Factor : Hanning 1.44 ; Rectangular 0.89 ; Hamming 1.30 ; Blackman 1.68
2
200 Msa/s
14 bits
25 MHz
Sine, Square, Pulse, Ramp, DC, Noise, Sinc, Gaston, Lorentz, Exponential Rise, Exponential Fall, Haversine, Cardiac
20 mVpp to 5 Vpp, HighZ;10 mVpp to 2.5 Vpp, 50 Ω
1mV
2% (1 kHz)
±2.5 V, HighZ;±1.25 V, 50 Ω
1mV
Frequency Range:100mHz~25MHz ; Flatness:±0.5 dB( relative to 1kHz) ; Harmonic Distortion:-40 dBc ; Stray (Non-harmonic):-40 dBc ;
Total Harmonic Distortion:1% ; S/N Ratio:40 dB
Frequency Range:100mHz~15MHz ; Rise/Fall time:<15ns ; Overshoot: <3% ; Duty cycle Square:50% & Pulse:0.4%~99.6% ;
Min. Pulse Width:30 ns ; Jitter:500 ps
Frequency Range:100mHz~1MHz ; Linearity: 1% ; Symmetry: 0~100%
RJ-45 connector, 10/100Mbps with HP Auto-MDIX
5V Max/10mA TTL open collector output
Rear-panel security slot connects to standard Kensington-style lock
Amplitude, Time, Gating Available; Unit : Seconds(S), Hz(1/S), Phase (Degrees), Ratio(%)
6 digits, range from 2Hz minimum to the rated bandwidth
Single-button, automatic setup of all channels for vertical, horizontal and trigger systems, with undo Autoset
20 sets
24 sets
YT ; XY
38 sets : Pk-Pk, Max, Min, Amplitude, High, Low, Mean, Cycle Mean, RMS, Cycle RMS, Area, Cycle Area, ROVShoot, FOVShoot, RPREShoot,
FPREShoot, Frequency, Period, RiseTime, FallTime, +Width, -Width, Duty Cycle, +Pulses, -Pulses, +Edges, -Edges, %Flicker, Flicker Idx., FRR, FRF,
FFR, FFF, LRR, LRF, LFR, LFF, Phase
GSC-008
Soft Carrying Case
GRA-426
GAK-003
Rack Adapter Panel
50 Impedance Adapter
GTL-246
USB Cable, USB 2.0, A-B Type, 1200mm
GDB-03
Oscilloscope Education & Training Kit
GCP-020
Current Probe, 40Hz~40kHz, 240A,
Current Probe
GCP-100
Current Probe, DC~100KHz, 100A, Current Probe
GCP-1030
Current Probe, DC~100MHz, 30Arms, Current Probe
GCP-206P
Current Probe - Power Supply, 2 Channel Power
Supply for GCP-530/1030
GCP-425P
Current Probe - Power Supply, 4 Channel Power
Supply for GCP-530/1030
GCP-530
Current Probe, DC~50MHz, 30Arms, Current Probe
GDP-025
Differential Probe, 25M High Voltage Differntial Probe
GDP-050
Differential Probe, 50M High Voltage Differntial Probe
GTP-033A
Oscilloscope Probe, 35MHz 1:1
Passive Probe
MDO2000GD21BH
Specifications subject to change without notice.
Note : Three-year warranty, excluding probes & LCD display panel.
DIMENSIONS & WEIGHT
POWER SOURCE
MISCELLANEOUS
DMM
SPECIFICATIONS
(MDO-2000EX only)
POWER SUPPLY
SOECIFICATIONS
(MDO-2000EX only)
Digit Level
DC Voltage
Accuracy
Input Impedance
DC Current
Accuracy
AC Voltage
Accuracy
AC Current
Accuracy
Resistance
Accuracy
Output Channel
Output Voltage Range
Output Current (Max.)
Voltage Step
Output Voltage Accuracy
Ripple and Noise
5,000 counts ;
CAT II 600Vrms, CAT III 300Vrms
50mV, 500mV, 5V, 50V, 500V, 1000V 6 ranges
50mV, 500mV, 5V, 50V, 500V, 1000V ±(0.1% reading + 5 digits)
10MΩ
50mA, 500mA, 10A 3 ranges
50mA~500mA (0.5% reading+0.05mA), 10A ±(0.5% reading + 50mA)
50mV, 500mV, 5V, 50V, 700V 5 ranges
50mV, 500mV, 5V, 50V, 700V ±(1.5% reading + 15 digits) at 50Hz~1kHz * Amplitude greater than 0.2% of the full scale reading.
50mA, 500mA, 10A 3 ranges
50mA, 500mA, ±(1.5% reading + 0.05mA)at 50Hz~1kHz ; 10A ±(3% reading + 50mA) at 50Hz~1kHz * Measure range: >10mA
500 sΩΩ Ω Ω Ω, 5k , 50k , 500k , 5M , 5 range
500 reading ; 5M ±(0.5% reading + 5 digits)ΩΩ Ω Ω Ω, 5k , 50k , 500k ±(0.3% + 3 digits)
CH1 & CH2
1.0V~5.0V
1A
0.1V Continuously Adjustable
±3%
50mVrms
SPECIFICATIONS
384(W) X 208(H) X 127.3(D)mm, Approx. 3 kg
Line Voltage Range
Multi-Language Menu
Time Clock
On-Line Help
Operation Environment
AC 100V ~ 240V, 48Hz ~ 63Hz, auto selection
Available
Available
Time and date, provide the date/time for saved data
Temperature: 0°C to 50°C. Relative Humidity: 80% at 40°C or below; 45%, 41°C ~ 50°C≤≤
ORDERING INFORMATION
100MHz,2Channel,Digital Storage Oscilloscope,Spectrum analyzer,dual channel 25MHz AWG
100MHz,4Channel,Digital Storage Oscilloscope,Spectrum analyzer,dual channel 25MHz AWG
200MHz,2Channel,Digital Storage Oscilloscope,Spectrum analyzer,dual channel 25MHz AWG
200MHz,4Channel,Digital Storage Oscilloscope,Spectrum analyzer,dual channel 25MHz AWG
OPTIONAL ACCESSORIES
MDO-2102E(G/X)
MDO-2202E(G/X)
MDO-2104E(G/X)
MDO-2204E(G/X)
70MHz,4Channel,Digital Storage Oscilloscope,Spectrum analyzer,dual channel 25MHz AWG
MDO-2074E(G/X)
70MHz,2Channel,Digital Storage Oscilloscope,Spectrum analyzer,dual channel 25MHz AWG
MDO-2072E(G/X)
ACCESSORIES
Quick start guide,User manual CD x 1,Power cord x 1,
FREE DOWNLOAD
GTP-070B-4 : 70MHz(10:1/1:1)Switchable passive probe for MDO-2072E(X)/2074E(X)(one per channel)
: 100MHz(10:1/1:1)Switchable passive probe for MDO-2102E(X)/2104E(X)(one per channel)GTP-100B-4
: 200MHz(10:1/1:1)Switchable passive probe for MDO-2202E(X)/2204E(X)(one per channel)GTP-200B-4
PC Software
OpenWave software
Driver
USB driver ; LabView driver
Global Headquarters
GOOD WILL INSTRUMENT CO., LTD.
No.7-1, Jhongsing Road, Tucheng Dist., New Taipei City 236, Taiwan
TF+886-2-2268-0389 [phone]
E-mail: [e-mail]
Simply Reliable
www.gwinstek.com www.facebook.com/GWInstek
GTL-110
BNC-BNC cable x 2,
GTL-105A
Alligator Clip test lead
(only on MDO-2000EX),
GTL-207
Banana plug test lead (only on MDO-2000EX)
“(X)” built in 5,000 counts DMM and power supply
FREQUENCY
RESPONSE
ANALYSIS
Dynamic Range
Input and Output Sources
Frequency Range
Number of Test Points
Test Amplitude
Test Results
Manual Measurements
Plot Scaling
> 80 dB (typical)
Channel 1 or 2 ( 3 or 4 for four channel model)
20 Hz to 25 MHz
10 to 90 points per decade
20 mVpp to 5 Vpp into High-Z Fixed amplitude across entire sweep
Logarithmic overlaid gain and phase plot
Two pairs of tracking gain and phase markers
Auto-scaled during test