Manual

OPERATION
13
READY Status
Description
When the tester is in READY status, it is ready
to begin testing. Pressing the START button
will begin testing and put the tester into TEST
status. Pressing the EDIT key will put the tester
into the EDIT status. Pressing the UTILIY key
will enter the Common Utility settings.
The READY status can also be used to set the
testing mode. The testing mode can be set to
run a single test at a time or to run two different
tests sequentially.
H = 2 2 . 0 m A m AL 0= 0 0. 7 4 S = 1T
CWDA CW R I DO EM T M EI
READY Status
Test mode
1 00
k V
AER D Y
Am
Set the Testing Mode
 Press the MODE soft-key to toggle between MODE
(single test) and each of the Auto Modes. (AC-IR,
IR-AC, DC-IR, IR-DC)
 The Auto Mode function sets two different test
functions and the order that will they run. I.e., AC-IR
means an ACW test is performed followed by an IR
test.
 When the unit is in TEST status, the Test Mode
determines whether a single test is run or if two tests
are run sequentially.
O D EM