Manual
Table Of Contents
GPT-9600 Series Quick Start Guide
14
Go to EDIT Status
Press the EDIT key.
EDIT
Set the Test Voltage
When in the READY mode, turn the scroll wheel
knob to set the test voltage.
Start Testing
Press the START button to begin testing.
The tester will go into TEST status.
START
WARNING
If Double Action is active, the START button must
be pressed within 500ms after the STOP button
was pressed to be able to start testing.
WARNING
If INTERLOCK is set to ON and the interlock key is
not connected to the SIGNAL I/O port,
INTERLOCK OPEN will be displayed on the screen,
preventing the test from starting. See page 19 for
the Common Utility settings.
EDIT Status
Description
EDIT status is used to edit the test parameters
(excluding the test voltage). Pressing the SAVE
key will save any changes and return to the
READY status. Pressing the ESC key will cancel
any changes and return to the READY status.
Pressing the UTILITY key will enter the TEST
Utility settings.