Manual

Legal notice

These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data processing

systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.

These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.

SETTING UP THE DEVICE

Set up the device, using the handle or the device’s pedestal, so it can be operated and read

comfortably.

Avoid direct sunlight over a longer period since this could damage the screen.

In order to comply with the tolerance information in the technical data, the

device must be in operation for approx. 20 minutes (or as specied in the

operating instructions) within the stated operating temperature range.

GETTING STARTED

Insert the supplied power cord into the power supply of the device and connect the plug to a

grounded power point.

Switch on the device with the power switch (POWER I/0).

The device shows a start screen and is ready for operation after a short initialisation phase.

Read the extensive operating instructions to make yourself familiar with the functions of the

product.

After use separate the connections and switch the product off.

CLEANING

Always observe the following safety instructions before cleaning the device:

If you open covers or remove parts – unless you can do this by hand – live

parts may be exposed.

Prior to cleaning or repairing the device, all lines must be detached and the

device must be turned off.

Do not use abrasive, chemical or aggressive cleaning agents such as benzene, alcohol etc.

These might attack the surface of the device. Furthermore, the fumes are hazardous to your

health and are explosive. Moreover, you should not use sharp-edged tools, screwdrivers or

metal brushes or such like for cleaning.

For cleaning the device or the display and the measuring cables, use a clean, slightly damp,

lint-free, antistatic cloth.

DISPOSAL

Electrical and electronic products do not belong to the household waste.

Dispose of an unserviceable product in accordance with the relevant statutory

regulations.

You thereby full your statutory obligations and contribute to the protection of the

environment!