Instructions

ASR-2000 Series User Manual
60
Basic Operation
This section describes the basic operations required to operate the
power supply.
 Select the Output Mode → from page 61
 Select the Voltage Range → from page 63
 Select the Output Waveform → from page 64
 Setting the Output Voltage Limit → from page 67
 Setting the Output AC/DC Voltage & Gain → from page 70
 Setting the Frequency Limit → from page 73
 Setting the Output Frequency & Signal → from page 76
 Setting the Peak Current Limit → from page 78
 Setting the Output Current Level → from page 80
 Setting the Output On Phase → page 82
 Setting the Output Off Phase → page 84
 Switch the Display Modes → from page 86
 Using the Measurement Function → from page 89
 Switch the Measurement Format → from page 92
 Panel Lock → from page 94
 Alarm Clear → from page 95
 Turning the Output On/Off → from page 96
Before operating the power supply, please see the Getting Started
chapter, page 9.