User Manual

ManualsBrandsGW INSTEK ManualsLaboratory Test EquipmentFunction Generator, Frequency Generator

SAFETY INSTRUCTIONS

precipitation, and full wind pressure, but neither temperature

nor humidity is controlled.

Storage

environment

 Location: Indoor

 Relative Humidity: < 70%

 Temperature: -10°C to 70°C

Disposal

Do not dispose this instrument as unsorted

municipal waste. Please use a separate collection

facility or contact the supplier from which this

instrument was purchased. Please make sure

discarded electrical waste is properly recycled to

reduce environmental impact.

Power cord for the United Kingdom

When using the function generator in the United Kingdom, make sure the

power cord meets the following safety instructions.

NOTE: This lead/appliance must only be wired by competent persons

WARNING: THIS APPLIANCE MUST BE EARTHED

IMPORTANT: The wires in this lead are coloured in accordance with the following code:

Green/ Yellow:

Earth

Blue:

Neutral

Brown:

Live (Phase)

As the colours of the wires in main leads may not correspond with the coloured

marking identified in your plug/appliance, proceed as follows:

The wire which is coloured Green & Yellow must be connected to the Earth terminal

marked with either the letter E, the earth symbol or coloured Green/Green &

Yellow.

The wire which is coloured Blue must be connected to the terminal which is marked

with the letter N or coloured Blue or Black.

The wire which is coloured Brown must be connected to the terminal marked with

the letter L or P or coloured Brown or Red.

If in doubt, consult the instructions provided with the equipment or contact the

supplier.

This cable/appliance should be protected by a suitably rated and approved HBC

mains fuse: refer to the rating information on the equipment and/or user instructions

for details. As a guide, a cable of 0.75mm

should be protected by a 3A or 5A fuse.

Larger conductors would normally require 13A types, depending on the connection

method used.

Any exposed wiring from a cable, plug or connection that is engaged in a live socket

is extremely hazardous. If a cable or plug is deemed hazardous, turn off the mains

power and remove the cable, any fuses and fuse assemblies. All hazardous wiring

must be immediately destroyed and replaced in accordance to the above standard.