User Manual User guide

APS-1102 LabVIEW Driver Manual
2-6
Limit Frequency Low [Hz]
This sets the lower limit of the frequency. The default setting is “1.0”.
<Output>
Output[Hz]
When Read = True, outputs the lower limit of the frequency set for the APS-1102. When
Read = False, “9999.9” is set.
GW APS-1102 SOUR Func.vi
This sets the output waveform.
In the AC-EXT or AC+DC-EXT mode, output waveform setting is disabled. (A [3,"Invalid in this
mode"] error occurs.)
<Input>
Select Function
This sets the output waveform. The default setting is “SIN”.
<Output>
Query Function
When Read = True, outputs the output waveform set for the APS-1102. When Read=False,
“space” is set.
GW APS-1102 SOUR Mode.vi
This sets the output mode. There are eight output modes, each of them is a combination of one
operation mode (AC or AC+DC) and one signal source mode (INT, EXT, ADD, or SYNC).
Consequently, the output mode setting is AC-INT, AC-EXT, AC-ADD, AC-SYNC, AC+DC-INT,
AC+DC-ADD, or AC+DC-SYNC.
However, when output is ON, the output mode cannot be changed. ([1, “Invalid with output on”]
error occurs.]
<Input>
Select Mode
This sets the output mode. The default setting is “AC-INT”.
<Output>
Query Mode
When Read = True, outputs the output mode set for the APS-1102. When Read = False,
“space” is set.
GW APS-1102 SOUR Phas Cloc.vi
This sets the sync signal source in the external synchronization mode (AC-SYNC or AC+DC-SYNC).