User Manual User guide

2.4 VISA Initialization
2-11
AC output voltage is set using the Vrms unit (when the waveform is SIN or SQU) or Vp-p units
(when waveform is ARB). When in AC-EXT or AC+DC-EXT mode, the output AC voltage cannot be
set or queried. ([3,"Invalid in this mode"] error occurs.)
<Input>
Voltage[Vpp]/[Vrms]
This sets the output AC voltage. Setting range varies according to waveform and range.
The default setting is “0.0”.
<Output>
Output[Vpp]/[Vrms]
When Read = True, outputs the output AC voltage set for the APS-1102. When Read=False,
“999.9” is set.
GW APS-1102 SOUR Volt High.vi
This sets the upper limit of the output voltage that can be set. However, a value that is at or below
the currently set cannot be specified. ([5,"Out of Limiter"] error occurs.)
<Input>
High_Rn100V [V]
This sets the upper limit of the output average voltage in the 100 V range. The default
setting is “200.0”.
High _Rn200V [V]
This sets the upper limit of the output average voltage in the 200 V range. The default
setting is “400.0”.
Rn_set
This specifies the range to be set. The default setting is “100 V (False)”.
<Output>
Output [V]
When Read = True, outputs the upper limit of the output voltage set for the APS-1102.
When Read = False, “999.9” is set.
GW APS-1102 SOUR Volt Low.vi
This sets the lower limit of the output voltage that can be set. However, a value that is at or below
the currently set cannot be specified. ([5,"Out of Limiter"] error occurs.)
<Input>
Low_Rn100V[V]
This sets the lower limit of the output average voltage in the 100 V range. The default
setting is “–200.0”.
Low_Rn200V[V]
This sets the lower limit of the output average voltage in the 200 V range. The default