User Manual User guide

APS-1102 LabVIEW Driver Manual
2-28
2.15 Common commands
GW APS-1102 CLS.vi
This clears the following registers:
 Standard event register
 Operation event register
 Warning event register
 Status byte
 Error queue
GW APS-1102 ESE.vi
This sets the standard event enable register. The setting range is 0 to 255.
<Input>
ESE
This sets the standard event enable register. The default setting is “0”.
<Output>
Query ESE
When Read = True, outputs the standard event enable register set for the APS-1102. When
Read = False, “999” is set.
GW APS-1102 ESR.vi
This returns the standard event register value. When ESR reads the standard event register, all bits
in the event register are cleared to 0. The response range is 0 to 255.
<Output>
Query ESR
This outputs the standard event register set for the APS-1102.
GW APS-1102 IDN.vi
This returns model name, etc. The response message includes the “manufacturer, model name,
serial number, and firmware version”.
<Output>
Query IDN
This outputs the model name and other information of the APS-1102.