User Manual

ASR-2000 Series User Manual
132
Branch1/
Branch2
The Branch settings allow you to
make a selectable branch within the
sequence when the sequence is
running or on hold. The branch1 or
branch2 actions are enabled by
pressing the F1 or F2 function keys,
or by using
the :TRIG:SEQ:SEL:EXEC remote
control command. After the branch
step(s) have completed the unit will
return back to the step from which
the branch was executed and
continue to run the step from where
it left off.
Term
(Termination)
Determines the step termination
settings at end of the step.
The CONTI setting tells the
sequence to go to the next step.
The HOLD setting will pause the
output at the end of the step and
will only continue to the next step
when CONTI [F3] is pressed.
The END setting will end the
sequence and go to Step 0(standby
step).
Sync Code
Sets the synchronous code
including LL, LH, HL and HH for
each step.
ON/OFF Phs
Sets the start and stop phase of the
AC waveform for each step. The ON
Phs setting sets the starting phase
of the step .
OFF Phs sets the off phase for the
output when the output if turned
off.
Note: it is available for AC+DC-INT
and AC-INT modes only.