Manual

CONFIGURATION
5
Interface Overview
Rear panel








 


Power
socket
Fuse
socket
RS232C
port
USB Slave
Connector
Power
switch
Calibration Output
Terminal
GO-NoGO Output
Terminal
USB Host
Connector
Interface type
Terminal
application
(USB/RS-232C)
Invoke the terminal application such as MTTTY
(Multi-Threaded TTY).
 For USB, set the COM port to COM7. No other
setting is required.
 For RS-232C, set the COM port, baud rate, stop
bit, data bit, and parity accordingly.
To check the COM port No. for RS-232C, see the
Device Manager in the PC. For WinXP, Control
panel → System → Hardware tab.