User Manual

GCP Series User Manual

MEASURE PROCEDURE

Preparations for Measurement (Current

Probe)

Procedure

1. Have the GCP-206P or GCP-425P POWER

SUPPLY, and oscilloscope or recorder for

waveform measurement ready.

CAUTION

Before turning on the power, make sure that the

voltage of the power supply being used matches the

supply voltage indicated on the rear panel of the

GCP-206P or GCP-425P

NOTE

The output of this device is terminated internally.

Use a high-impedance input to the measuring

instrument. With an input impedance of 50Ω,

accurate measurement is not possible.

2. Turn the power switch off and connect the

power cord.

3. Connect the power plug of the GCP-530 or GCP-

1030 to the power receptacle of the GCP-206P or

GCP-425P.