User Manual

GCP Series User Manual

Un-insulated

(core and

shield case)

• Be careful to avoid damaging the insulation

surface while taking measurements.

• This instrument is made for use with the GCP-

206P or GCP-425P POWER SUPPLY. It is possible

to use a power supply other than the GCP-206P or

GCP-425P, provided that the connector and pin

assignments match, and that voltage and other

electrical specifications are satisfied. In the interest

of safety, make sure that the power supply has a

protective earthing with double- insulation

construction.

• Make sure that the waveform measuring

equipment connected to this device's output

terminal (BNC) is equipped with a protective

earthing with double-insulation construction.

• If the waveform measuring instrument being

connected to the output terminal (BNC) on this

device is equipped with any other measurement

terminals, take the following precautions to ensure

that the other instrument does not form a bridge

between the probe and any hazardous live of a

part.

1. Isolate the terminal to which the probe is

connected from other terminals on the measuring

instrument using basic insulation conforming to

the measurement category, working voltage, and

pollution degree requirements of the circuit being

tested.