User guide

MEASUREMENT OPERATION

Warning

Before connecting the Meter to the return circuit to be tested, cut off the current

of the return circuit.

If the fuse burns out during measurement, the Meter may be damaged or the

operator may be hurt.

Use the proper terminals, function, and range for each measurement.

When the testing leads are connected to the current terminals, do not connect

them in parallel to any circuit.

To measure current, do the following:

1. Insert the red test lead into the μmA or A input terminal and the black test lead

into the COM terminal.

2. Set the rotary switch to μA, mA, or A.

3. The Meter defaults to DC current measurement mode. To toggle between the

DC and AC current measurement function, press the BLUE button.

4. Connect the test lead in series to the return line of the circuit to be tested. The

measured value is shown on the display.

GDM-397/398: Displays the effective value of sine wave (mean value response).