User guide

MEASUREMENT OPERATION

Note

 The test leads can add 0.2Ω to 0.5Ω of error to the resistance measurement. To

obtain precise readings for low-resistance measurements, short the leads

beforehand to obtain the resistance of the test leads and use the relative

measurement function button, REL

to automatically subtract the resistance of

the test leads from the measured value.

 If the Ω reading with shorted test leads is not ≤0.5Ω, check to see that the test

leads are properly connected and are not loose.

 For high-resistance measurements (>1MΩ), it is normal to take several seconds

to obtain a stable reading. To obtain a stable reading, use test leads that are as

short as possible or use the included multi-purpose socket to carry out the

measurement.

 The LCD displays OL to indicate an open-circuit or that the resistor value is

higher than the selected range of the Meter.

 When resistance measurement has been completed, disconnect the connection

between the testing leads and the circuit under test, and remove the testing leads

away from the input terminals of the Meter.