User Manual Owner manual

DUAL DISPLAY DIGITAL MULTIMETER

USER MANUAL

FOR UNITED KINGDOM ONLY

NOTE: This lead/appliance must only be wired by

competent persons

WARNING: THIS APPLIANCE MUST BE EARTHED

IMPORTANT: The wires in this lead are coloured in

accordance with the following code:

Green/ Yellow: Earth

Blue: Neutral

Brown: Live(Phase)

As the colours of the wires in main leads may not

correspond with the colours marking identified in your

plug/appliance, proceed as follows:

The wire which is coloured Green & Yellow must be

connected to the Earth terminal marked with the letter E or

by the earth symbol

or coloured Green or Green &

Yellow.

DUAL DISPLAY DIGITAL MULTIMETER

USER MANUAL

The wire which is coloured Blue must be connected to the

terminal which is marked with the letter N or coloured Blue

or Black.

The wire which is coloured Brown must be connected to the

terminal marked with the letter L or P or coloured Brown or

Red.

If in doubt, consult the instructions provided with the

equipment or contact the supplier.

This cable/appliance should be protected by a suitably rated

and approved HBC mains fuse: refer to the rating

information on the equipment and/or user instructions for

details. As a guide, cable of 0.75mm² should be protected

by a 3A or 5A fuse. Larger conductors would normally

require 13A types, depending on the connection method

used.

Any moulded mains connector that requires removal

/replacement must be destroyed by removal of any fuse &

fuse carrier and disposed of immediately, as a plug with

bared wires is hazardous if a engaged in live socket. Any

re-wiring must be carried out in accordance with the

information detailed on this label.