User Manual

MEASUREMENT
49
Procedure
1. Connect the input signal to
the oscilloscope and press
the Autoset key.
Autoset
2. The waveform(s) appears in the center of the
display.
Undoing the
Autoset
To undo the Autoset, press
Undo (available for a few
seconds).
Adjusting the
trigger level
If the waveform is still
unstable, try adjusting the
trigger level up or down by
using the Trigger Level knob.
L
EVE L
Change Modes
To change the type of mode,
press Type (available for a few
seconds). The Type icon will
change to next type.
Type
Fit Screen, AC Priority
The next time the Autoset key is pressed, the new
mode will be activated.