User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
109
Run Command
:RUN
Set
Description
The run command allows the oscilloscope to
continuously make acquisitions (equivalent to
pressing the Run key on the front panel).
Syntax
:RUN
Stop Command
:STOP
Set
Description
The stop command stops the oscilloscope making
further acquisitions (equivalent to pressing the
Stop key on the front panel).
Syntax
:STOP
Single Command
:SINGle
Set
Description
The single command allows the oscilloscope to
capture a single acquisition when trigger
conditions have been fulfilled (equivalent to
pressing the Single key on the front panel).
Syntax
:SINGle