User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
165
:BUS1:PARallel:WIDth
Set
Query
Description
Sets or queries the number of bits for the parallel
bus.
Syntax
:BUS1:PARallel:WIDth {<NR1> | ? }
Parameter/Return
parameter
<NR1>
1~16
Example
:BUS1:PARallel:WIDth 16
Sets the width of the bus to 16 bits.
:BUS1:DISplay:FORMAt
Set
Query
Description
Sets or queries the display format for the bus,
either binary or hexadecimal.
Syntax
:BUS1:DISplay:FORMAt { BINary | HEXadecimal | ? }
Parameter/Return
parameter
BINary
Binary format
HEXadecimal
Hexadecimal format
Example
: BUS1:DISplay:FORMAt BINary
Sets the display format to binary.