User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
171
Example
:SEARCH:TRIGger:SOURce CH1
Sets the search trigger source as CH1.
:SEARCH:TRIGger:EDGE:SLOP
Set
Query
Description
Sets or queries the search trigger slope.
Syntax
:SEARCH:TRIGger:EDGe:SLOP { RISe | FALL | EITher
| ? }
Related
commands
:SEARCH:TRIGger:TYPe
Parameter
RISe
Rising slope
FALL
Falling slope
EITher
Either rising or falling slope
Return parameter
Returns the trigger slope.
Example
:SEARCH:TRIGger:EDGe:SLOP FALL
Sets the search trigger slope to falling.
:SEARCH:TRIGger:LEVel
Set
Query
Description
Sets or queries the search trigger level.
Syntax
:SEARCH:TRIGger:LEVel {TTL | ECL| SETTO50 |
<NRf> | ?}
Related
commands
:SEARCH:TRIGger:TYPe
Parameter
<NRf>
Trigger level value
TTL
Sets the search trigger level to TTL.
ECL
Sets the search trigger level to ECL.
SETTO50
Sets the search trigger level to the
User level (50% by default).
Return parameter
<NR3>
Returns the trigger.