Datasheet

GDS-2000A Series User Manual
6
Do not dispose electronic equipment as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased.
Safety Guidelines
General
Guideline
CAUTION
 Make sure the BNC input voltage does not
exceed 300V peak.
 Never connect a hazardous live voltage to the
ground side of the BNC connectors. It might
lead to fire and electric shock.
 Do not place any heavy object on the GDS-
2000A.
 Avoid severe impact or rough handling that
leads to damaging the GDS-2000A.
 Do not discharge static electricity to the GDS-
2000A.
 Use only mating connectors, not bare wires, for
the terminals.
 Do not block the cooling fan opening.
 Do not perform measurement at a power source
or building installation site (Note below).
 Do not disassemble the GDS-2000A unless you
are qualified.
(Measurement categories) EN 61010-1:2010 specifies the
measurement categories and their requirements as follows. The
GDS-2000A falls under category I.
 Measurement category IV is for measurement performed at the
source of low-voltage installation.
 Measurement category III is for measurement performed in the
building installation.
 Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
 Measurement category I is for measurements performed on
circuits not directly connected to Mains.