User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
131
SPI
SPI mode
UART
UART mode
PARALLEL
Parallel mode
Example
:TRIGger:BUS:TYPe?
UART
:TRIGger:BUS:B1:I2C:CONDition
Set
Query
Description
Sets or queries the I
2
C trigger conditions.
Syntax
:TRIGger:BUS:B1:I2C:CONDition
{STARt | STOP | REPEATstart | ACKMISS | ADDRess |
DATA | ADDRANDDATA | ? }
Parameter
STARt
Set Start as the I
2
C trigger
condition.
STOP
Set Stop as the I
2
C trigger
condition.
REPEATstart
Set Repeat of Start as the I
2
C
trigger condition.
ACKMISS
Set Missing Acknowledgement
as the I
2
C trigger condition.
ADDRess
Set Address as the I
2
C trigger
condition.
DATA
Set Data as the I
2
C trigger
condition.
ADDRANDDATA
Set Address and Data as the I
2
C
trigger condition.
Return parameter
Returns the I
2
C bus trigger condition.
Example
:TRIGger:BUS:B1:I2C:CONDition ADDRess
Set Address as the I2C trigger condition.