User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
147
Save/Recall Commands
:RECAll:SETUp ...........................................................147
:RECAll:WAVEform ....................................................148
:SAVe:IMAGe .............................................................148
:SAVe:IMAGe:FILEFormat .........................................149
:SAVe:IMAGe:INKSaver .............................................149
:SAVe:SETUp ..............................................................149
:SAVe:WAVEform .......................................................150
:SAVe:WAVEform:FILEFormat ..................................151
:RECAll:SETUp
Set
Description
Recalls setup settings from memory or USB.
Syntax
:RECAll:SETUp {S1~S20 | <file
path>("Disk:/xxx.SET","USB:/xxx.SET")}
Parameter
S1~S20
Recall Set1~Set20
<file path>
Recall a file from the DSO internal files
system or from a USB flash drive.
Example
:RECAll:SETUp S1
Recalls setup setting S1 from memory.
:RECAll:SETUp “Disk:/DS0001.SET”
Recall setup setting DS0001.SET from system internal
disk.