User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
155
Bus Decode Commands
:BUS1 .........................................................................155
:BUS1:STATE .............................................................156
:BUS1:TYPe ................................................................156
:BUS1:I2C:ADDRess:RWINClude ..............................157
:BUS1:I2C:SCLK:SOURce ..........................................157
:BUS1:I2C:SDA:SOURce ............................................157
:BUS1:UART:BITRate .................................................158
:BUS1:UART:PARIty ...................................................159
:BUS1:UART:PACKEt .................................................159
:BUS1:UART:EOFPAcket ...........................................159
:BUS1:UART:TX:SOURce ..........................................160
:BUS1:UART:RX:SOURce ..........................................160
:BUS1:SPI:SCLK:POLARity ........................................161
:BUS1:SPI:SS:POLARity .............................................161
:BUS1:SPI:WORDSize ...............................................161
:BUS1:SPI:BITORder .................................................162
:BUS1:SPI:SCLK:SOURce ..........................................162
:BUS1:SPI:SS:SOURce ...............................................162
:BUS1:SPI:MOSI:SOURce .........................................163
:BUS1:SPI:MISO:SOURce .........................................163
:BUS1:PARallel:BIT<X>:SOURce ...............................163
:BUS1:PARallel:CLOCK:EDGE ...................................164
:BUS1:PARallel:CLOCK:SOURce ...............................164
:BUS1:PARallel:WIDth ...............................................165
:BUS1:DISplay:FORMAt ............................................165
:BUS1
Query
Description
Returns the supported BUS types.
Syntax
:BUS1?
Return Parameter
Returns the supported bus types.