User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
GDS-2000A Programming Manual
164
Syntax
:BUS1:PARallel:BIT<X>:SOURce{ D0 | D1 | D2 | D3 |
D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 |
D14 | D15 | ? }
Parameter/Return
parameter
<X>
Bit number: 0~15
D0 to D15
Digital channels D0 to D15
Example
:BUS1:PARallel:BIT0:SOURce D0
Assigns D0 to bit 0.
:BUS1:PARallel:CLOCK:EDGE
Set
Query
Description
Sets or queries the clock edge configuration for the
parallel bus.
Syntax
:BUS1:PARallel:CLOCK:EDGE
{ RISe | FALL | EITher | OFF | ? }
Parameter/Return
parameter
FALL
Sets the clock edge to falling edge.
RISe
Sets the clock edge to rising edge.
EITher
Sets the clock edge to rising or falling.
OFF
Disables the clock edge setting.
Example
:BUS1:PARallel:CLOCK:EDGE FALL
Sets the clock edge to falling edge.
:BUS1:PARallel:CLOCK:SOURce
Set
Query
Description
Sets or queries which channels are assigned as the
clock source.
Syntax
:BUS1:PARallel:CLOCK:SOURce { D0 | D1 | D2 | D3 |
D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 |
D14 | D15 | ? }
Parameter/Return
parameter
D0 to D15
Digital channels D0 to D15
Example
:BUS1:PARallel:CLOCK:SOURce D0
Assigns D0 as the clock source.