User manual

GDS-2000A Specification_EN 2 OF 4 2/27/2013
100MHz ~ 200MHz Approx. 1.5div or 15mV
200MHz ~ 300MHz Approx. 2div or 20mV
External Trigger
Range ±15V
Sensitivity DC ~ 100MHz Approx. 100mV
100MHz ~ 200MHz Approx. 150mV
200MHz ~ 300MHz Approx. 150mV
Input
Impedance
1MΩ±3// 16pF
Horizontal
Time base
Range
1ns/div ~ 100s/div (1-2-5 increments)
ROLL: 100ms/div ~ 100s/div
Pre-trigger 10 div maximum
Post-trigger 1000 div maximum.
Accuracy ±20 ppm over any ≥ 1 ms time interval
Real Time
Sample Rate
1CH: 2GSa/s; 2CH: 1GSa/s
ET Sample
Rate
100GSa/s maximum for all models
Record Length 1CH: 2Mpts; 2CH: 1Mpts
Acquisition
Mode
Normal, Average, Peak Detect, Single
X-Y Mode
Peak
Detection
2nS (typical)
Average selectable from 2 to 256
X-Axis Input Channel 1; Channel 3*
*four channel models only
Y-Axis Input Channel 2; Channel 4*
*four channel models only
Phase Shift ±3° at 100kHz
Cursors and Measurement
Cursors Amplitude, Time, Gating available
Automatic
Measurement
36 sets: Pk-Pk, Max, Min, Amplitude, High, Low, Mean, Cycle Mean, RMS, Cycle RMS, Area, Cycle Area,
ROVShoot, FOVShoot, RPREShoot, FPREShoot, Frequency, Period, RiseTime, FallTime, +Width, -Width,
Duty Cycle, +Pulses, -Pulses, +Edges, -Edges, FRR, FRF, FFR, FFF, LRR, LRF, LFR, LFF, Phase
Control Panel
Function
Cursors measurement
Auto counter 6 digits, range from 2Hz minimum to the rated bandwidth
Autoset Single-button, automatic setup of all channels for vertical, horizontal and trigger systems, with undo Autoset
Save Setup 20set
Save
Waveform
24set