User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
45
Vertical Commands
:CHANnel<X>:BWLimit .............................................. 45
:CHANnel<X>:COUPling ............................................ 46
:CHANnel<X>:DESKew .............................................. 46
:CHANnel<X>:DISPlay ............................................... 46
:CHANnel<X>:EXPand ............................................... 47
:CHANnel<X>:IMPedance? ........................................ 47
:CHANnel<X>:INVert ................................................. 48
:CHANnel<X>:POSition ............................................. 48
:CHANnel<X>:PROBe:RATio ..................................... 49
:CHANnel<X>:PROBe:TYPe ....................................... 49
:CHANnel<X>:SCALe ................................................. 49
:CHANnel<X>:BWLimit
Set
Query
Description
Sets or returns the bandwidth limit on/off.
Syntax
:CHANnel<X>:BWLimit {FULL | <NR3> | ?}
Parameter
<X>
Channel 1,2,3,4
FULL
Full bandwidth
<NR3>
Sets the bandwidth limit to a pre-defined
bandwidth.
200E+6: 200MHz
100E+6: 100MHz
20E+6: 20MHz
Return Parameter
<NR3>
Returns the bandwidth.
Full
Full bandwidth
Example
:CHANnel1:BWLimit 2.000E+07
Sets the channel 1 bandwidth 20MHz