User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
GDS-2000A Programming Manual
72
:DISPlay:WAVEform
Set
Query
Description
Sets or queries whether the waveforms are drawn
as vectors or dots.
Syntax
:DISPlay:WAVEform {VECTor | DOT | ?}
Parameter
VECTor
Vectors
DOT
Dots
Return parameter
Returns VECTOR or DOT.
Example
:DISPlay:WAVEform VECTor
Sets the waveform to vectors.
Hardcopy Commands
:HARDcopy:START ...................................................... 72
:HARDcopy:MODe ...................................................... 73
:HARDcopy:PRINTINKSaver ....................................... 73
:HARDcopy:SAVEINKSaver ......................................... 73
:HARDcopy:SAVEFORMat .......................................... 74
:HARDcopy:ASSIGN .................................................... 74
:HARDcopy:START
Set
Description
Executing the HARDcopy:START command is the
equivalent of pressing the Hardcopy key on the
front panel.
Syntax
:HARDcopy:START
Related
Commands
:HARDcopy:MODe
:HARDcopy:PRINTINKSaver
:HARDcopy:SAVEINKSaver
:HARDcopy:SAVEFORMat
:HARDcopy:ASSIGN