User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
COMMAND DETAILS
99
Measurement Commands
:MEASUrement:MEAS<X>:SOURCE<X> ................... 99
:MEASUrement:MEAS<X>:TYPe ...............................100
:MEASUrement:MEAS<X>:STATE ............................100
:MEASUrement:MEAS<X>:VALue.............................101
:MEASUrement:MEAS<X>:MAXimum .....................102
:MEASUrement:MEAS<X>:MEAN ............................103
:MEASUrement:MEAS<X>:MINImum .....................103
:MEASUrement:MEAS<X>:STDdev ..........................104
:MEASUrement:STATIstics:MODe ...........................104
:MEASUrement:STATIstics:WEIghting .....................105
:MEASUrement:STATIstics .......................................105
:MEASUrement:MEAS<X>:SOURCE<X>
Set
Query
Description
Sets or queries the measurement source for a
selected automatic measurement. This is a statistics
related command.
Syntax
:MEASUrement:MEAS<X>:SOURCE<X> { CH1 | CH2 |
CH3 | CH4 | MATH | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15 | ? }
Related
commands
:MEASUrement:MEAS<X>:TYPe
Parameter
MEAS<X>
The automatic measurement number
from 1 to 8.
SOURCE<X>
SOURCE1: the source for all single
channel measurements.
SOURCE<X>
SOURCE2: the source for all delay or
phase measurements.
CH1 to CH4
Channel 1, 2, 3, 4
MATH
Math source
D0 to D15
Digital channel sources D0 to D15