Datasheet

Unfiltered Waveform with
Noise Interference
Filtered Waveform,
Noise Removed
G.
I.
Users Can Also Select “Analyze Segments” to Conveniently Obtain
The Analysis Results.
DIGITAL FILTER FUNCTION
SEGMENTED MEMORY FUNCTION
Users can rapidly search desired waveforms according to the trigger
condition. After activating the search function, hollow inverted
triangles will show the location met the trigger condition. The upper
left hand corner Overall will show the total number of waveforms
met the trigger condition. Users can set waveform search by the
trigger condition such as Edge, pulse width, Runt, Rise/Fall, and Bus.
When the trigger condition is met, hollow inverted triangles will
appear. Users can save all marks to compare with the next input
signal. The front panel of the MSO-2000 series controls waveform
zoom-out and play/pause function to swiftly identify each desired
event. The function allows users to conveniently complete waveform
search and save marks for rapid comparison and analysis.
Engineers are often troubled by noise interference while measuring
signals in the electric circuit tests. The MSO-2000 series features
the digital filter function which can be set to high pass or low pass
digital filter. Digital filter allows users to independently set filter
frequency for each channel. The tracking on function rapidly sets
same filter frequency for all channels.
To achieve the most ideal application for memory depth, the MSO-
2000 series has the built-in segmented memory function. The
segmented memory function allows users to select the desired
important signals for observation. Hence, insignificant signals can
be neglected and serial bus decoding; pulse or inrush signals can
be identified when retrieving signals. The segmented memory
function of the MSO-2000 series allows users to select the number
of sections. The maximum sections can be selected are 29,000.
After activating the function, users can select and observe waveform
for each segment by turning the Variable knob. The ultimate
application of memory depth, therefore, is completely realized.
Users, via the data log function, can observe waveform changes
in long periods of time to ensure product reliability or measure
sporadically appeared signals. The data log function, based on
the requirements, can set record time and interval. Record time
can be selected from 5 minutes to 100 hours, and record interval
is 5 seconds, the minimum. Waveform type for record data and
CSV file format for each channel can also be selected. Data can
be stored in USB drive, the MSO-2000 series or the remote
computer via LAN.
F.
H.
DATA LOG FUNCTION
WAVEFORM SEARCH FUNCTION
The MSO-2000 series provides the Mask function, which allows
users to apply Auto Mask and user-defined Mask to determine
whether the quality of the product meets the regulation. Via user-
defined mask, users can set up to 8 areas and each area is up to
J.
MASK FUNCTION
10 points to meet test requirements. Users can also refer to the
examples from user manual to edit Mask by the PC to satisfy all
test needs. By setting Save On, users can log and monitor signals,
which violate test conditions.