User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
99
:FSEQuence:LAST ............................................................. 122
:FSEQuence:RPTStep ........................................................ 123
:FSEQuence:EDIT ............................................................. 123
:FSEQuence:EDIT:POINt ............................................... 124
:FSEQuence:EDIT:END? ................................................ 125
:FSEQuence[:DELet]:ALL ................................................ 125
:FSEQuence[:EDIT]:FILL ................................................ 125
:FSEQuence:SAVE ............................................................ 126
:PROGram:STATe
Set
Query
Description
Sets or queries the state of the program function.
Syntax
:PROGram:STATe {ON|OFF|PAUSe|CONTinue|NEXT}
Query Syntax
:PROGram:STATe? {{ON,STOP|RUN|PAUSe}|OFF}
Parameter
ON
Turn program on
OFF
Program off
PAUse
Program pause
RUN
Program running
NEXT
Next step in the program
CONTinue
Program continue
Return Parameter
ON,STOP
Program is on, stopped
ON,PAUSE
Program is paused
ON,RUN
Program is running
OFF
Program is off
Example
:PROGram:STATe ON
Turns “Program” on.
Query example
:PROGram:STATe?
>OFF
“Program” is off.