User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
101
Example
:PROGram: 1,1,1,AUTO,2.0,OFF,1.0,OFF
Sets the program settings as follows: Program no. = 1,
Step no. = 1, memory number = M001, Run = AUTO,
On-Time = 2.0 secs, Off-Time = OFF, P/F Time = 1.0
secs, Short-Time = OFF.
Query example
:PROGram?
>Program:ON; Start:1, Step:1, Memory:1,
Run:Manual, On-Time:2.0, Off-Time:0.0, P/F-Time:0.0,
Short-Time:0.0
Returns the program settings for program number 1,
at step 1.
:PROGram[:RECall]:DEFault
Set
Description
The default settings for the program sequence
function.
Syntax
:PROGram[:RECall]:DEFault
Example
:PROGram:DEFault
:PROGram:STARt
Set
Query
Description
Sets or queries the program number for the
program sequence.
Syntax
:PROGram:STARt {<NR1>}
Query Syntax
:PROGram:STARt?
Parameter
<NR1>
(1~16) program number
Return Parameter
<string>
Start:<NR1>
Example
:PROGram:STARt 1
Sets the program number to 1.
Query example
:PROGram:STARt?
>Start:1
Returns the program number (1).